![]() ![]() ![]() You don't need the problem for this, but this installs the correct drivers on your PC.Ĥ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1, "use USB Com Port as COM2" to "Yes" and submit/apply changes.ĥ) Plug a USB cable between your PC and control-RRC. This rate keeps traffic over the internet to a minimum and faster is not necessary for CAT.Ģ) Change the COM2 serial settings of the radio-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.ģ) Change the COM2 serial settings of the control-RRC to mode-4, 4800 baud, data bits 8, stop bits 1 and submit/apply changes.Ĥ) Plug a serial cable in between your PC and the control-RRC COM2ĥ) Set your software to use the correct COM port on your PC at -Nģ) Install the Microbit Setup Manager if you already haven't. IMPORTANT: In both scenarios, you MUST first install a standard serial cable between the TS-480 body and COM2 of the radio RRC!ġ) Change the CAT rate on the TS-480 to 4800 baud (menu 56). I have a checklist for setting-up CAT on the TS-480 as follows: ![]() From your comments, I assume you didn't read the manual. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |